Cutting plotters are mainly made for cutting relatively thin flexible media like vinyl. Typical applications include vinyl lettering, as well as cutting out pre-printed stickers, decals as well as some short-run labelling applications. They’re considerably less than a cutting table and must easily purchase themselves in a relatively short time frame. Obviously fabric cutter must be able to cutting right through flexible substrates such as self adhesive vinyl. Nevertheless they must also offer options like perforation and cutting only part-way through a material to create a tear-off line.
It’s important to check the cutting force and this any prospective plotter can handle the type of substrates that you wish to use. Otherwise, deciding on a plotter is mainly a case of balancing its cost versus the cutting speed as well as the volume of work you have. There’s a good quantity of cutting plotters available so as opposed to proceed through all of them we’ll highlight among the most common as well as the features you can typically expect from these plotters.
Mutoh has additionally considered the print and cut workflow, which happens to be essential if you’re going so that you can put the prints by way of a cutter with accurate registration. The dual heads vinyl cutter come with FlexiStarter software for adding cutting paths to create files. Additionally, it may produce a reference mark for your ValueCut machines to locate the style. Mark Rammant, product specialist for Mutoh, adds: “You can even create marks in a graphic design software like Illustrator. You are able to import these to the FlexiStarter software and it will automatically put these contour lines through by using a chosen spot colour and swatch name by recognizing this spot colour as cutting data.” He states that the ValueCut plotters will likely recognize cut paths off their programs such as Onyx RIP, that also supports print and cut workflows. Summa also has several vinyl cutting options. The typical Summacut comes in 142cm and 164cm widths, whilst the newer D140 FX, only will come in the 142cm size. This may cut at up to 113cm per second with as many as 3G acceleration or higher to 400g knife pressure.
Summa also provides the better heavy-duty S class, made for high volume industrial work. These are available in two series: the D-series utilize a drag knife and may cut using a force of up to 400g; the T series works with a true tangential knife and might apply approximately 600g cutting force. They’re obtainable in four sizes with cutting widths of 74cm, 120cm, 135cm and 158cm. They may cut at up to 1000mm per second with optional consume rollers and media racks accessible for the most important two sizes. All 37dexhpky systems utilize an automated optical system that picks up marks on the print to align the cutting blades and all sorts of support barcodes. There’s also an optional camera system for the S2 T-series. Mimaki has the CG FX series, available in 760mm, 1300mm and 1600mm widths. They’re intended for vinyl work and definately will take media around .25mm thick. They can apply approximately 400g of pressure and cut at approximately 100cm per second. There’s an optical sensor to detect registration marks about the print plus they come supplied with best vinyl cutter plug-because works jointly with either CorelDraw or Adobe Illustrator. Mimaki also sells the CG-SRIII series, available too in three sizes, with cutting widths around 606mm, 1070mm and 1370mm. These may bring 500g of pressure to deal with only cut at up to 70cm per second.